The Stainless Steel Sink Manufacturers Tells You That The Sink

  • If you buy a stainless steel sink, one of them is to touch the thickness of the sink. If a thin sink is a crime that cannot escape the craft, it is definitely not a good thing. If it is thicker, it will be better. what?

    In fact, this is not the case. The thicker it is, the better. The following AFA Stainless Steel Sink Manufacturers will discuss with you:

    1. The existing drawing tank has a thickness of about 0.8-1 mm. Because this thickness is usually used for decades, there is no problem unless there is violent damage. And this thickness is also the actual thickness of the integrated press. It is too thick and it will rupture if it is stretched. And the thickness of the stretching groove is most suitable.
    2. In addition to stretching the sink, the other is a manual sink. The manual sink is a sink formed by welding the gaps together after the machine is bent. Typically, the manual sink has a thickness of approximately 1.2 mm. The thickness is too high, but this means that the elasticity of the stainless steel is lost.
    3. Carefully replace low-cost stainless steel. Single-stretched stainless steel is too thick. If a small manufacturer replaces cheap 201 stainless steel or 304 stainless steel, the overall press will not help, although the seal is good, but the possibility of rust is increased. The service life of the sink is greatly reduced, and the sink is still 0.8--1.2, with a normal thickness.